From: Wu,Jiang (wujiang@xxxxxxxxx)
Date: Tue Oct 03 2000 - 08:07:00 GMT-3
Michael,
I tried RIP v1 an v2 between the two routers. Broadcasts are getting through an
d multicasts are not. Would you (or anyone out there) please give me a solution
since I have little experience on multicasts?
Regards,
-Wu
----- Original Message -----
From: Michael Bausenwein
To: Wu,Jiang
Sent: Tuesday, October 03, 2000 5:29 PM
Subject: Re: OSPF adjacency
have you done debugs on ip ospf neighbor??
That might shed some light.
Also have you tried a different routing protocol,like rip or eigrp. This will
tell you if broadcasts and multicasts are getting through
Michael Bausenwein
CCIE #5865
Senior Network Engineer
Greenwich Technology Partners
email:mbausenwein@greenwichtech.com
----- Original Message -----
From: Wu,Jiang
To: ccielab@groupstudy.com
Sent: Tuesday, October 03, 2000 4:19 AM
Subject: OSPF adjacency
Hi,
I have a Catalyst2948G-L3 and some of its ports are configured into one bridge
group. I used to think these ports should work as a normal switch. But when I c
onnect two routers to the ports, they cannot make OSPF adjacency with each othe
r(though they can ping each other). May the TTL expires on the Catalyst? Would
anyone please give me some ideas?
Thanks,
Wu
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:23 GMT-3