Re: loop back interfaces and ospf

From: mark salmon (masalmon@xxxxxxxxx)
Date: Fri Sep 29 2000 - 18:56:56 GMT-3

• Next message: Shaun Nicholson: "Re: writing on lab test"
• Previous message: mark salmon: "Re: loop back interfaces and ospf"
• Maybe in reply to: Connary, Julie Ann: "loop back interfaces and ospf"
• Next in thread: Tony Olzak: "Re: loop back interfaces and ospf"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
It is my understanding that ip ospf network point-to-multipoint's
drawback is it advertises the interface as a host route not a newwork
route (i.e. /32 mask)

Stylen wrote:
>
> goto interfeace config mode for the loopback interface and do a 'ip ospf
> network point-to-multipoint' then ospf will advertise ot with the correct
> mask. I think this is available in 11.3 and higher, not sure of the version
> exactly.
>
> Richard Foltz, CCNP, CCNP-Voice, CCDP, MCSE+I, Network+, A+
> Technical Solutions Consultant
> Sprint ENS

--
Mark Salmon
Network Support Engineer
SBC OP HQ
Cisco Systems Inc
8735 W. Higgins Road
Suite 300
Chicago IL 60631
Phone:773-695-8235
Pager:800-365-4578
email: masalmon@cisco.com
Empowering The Internet Generation.

• Next message: Shaun Nicholson: "Re: writing on lab test"
• Previous message: mark salmon: "Re: loop back interfaces and ospf"
• Maybe in reply to: Connary, Julie Ann: "loop back interfaces and ospf"
• Next in thread: Tony Olzak: "Re: loop back interfaces and ospf"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:09 GMT-3