From: Sam Munzani (sam@xxxxxxxxxxx)
Date: Mon Sep 11 2000 - 10:36:41 GMT-3
For lab use ip default network because you may not
be allowed to use any static routes. EIGRP understands ip default network
commnad just like IGRP.
Sam
> The key is to get it into the routing table. With EIGRP, we configure
> "ip route 10.0.0.0 255.0.0.0 (in this case) null 0.
>
> (this will work because the longest match rule should always allow a
> packet to find the right route instead of the glassful route. If a
> packet is received with no match, it will be dropped due to the null 0
> route statement so no routing loops are possible)
>
> David Ankers wrote:
> >
> > Refer to Jeff Doyle page 751 -> 753
> >
> > "After a default route is identified in the routing table, RIP, IGRP and
> > EIGRP will automatically advertise it. OSPF and IS-IS require some
aditional
> > configuration...."
> >
> > Hint: You don't need to do anything :-)
> >
> > ----- Original Message -----
> > From: "mark salmon" <masalmon@cisco.com>
> > To: <ccielab@groupstudy.com>
> > Sent: Sunday, September 10, 2000 11:34 PM
> > Subject: Re: EIGRp and default routes
> >
> > > Yep. however, I had to use an access list at the end as I received an
> > > incomplete command error. I then created a standard access list (
> > > acess-list 1 permit any), and it stil did not work.
> > >
> > >
> > > To test it I configured a IP network on a loopback interface on one of
> > > the EIGRP enabled router. I then used the command default information
> > > out under the EIGRP process.
> > >
> > > On one of the other routers I placed a default informatiion in
command.
> > > I then tried to ping the loopback interface of the original router. I
> > > was unsuccessful.
> > >
> > >
> > > Sam Munzani wrote:
> > > >
> > > > EIGRP is supposed to understand "ip default network" command.
However I
> > have
> > > > not tested it. As a matter of fact I could not make it work any way.
> > > >
> > > > I have not played with it but do you know the result of following
> > command?
> > > >
> > > > Router eigrp 1
> > > > default-information out ?
> > > >
> > > > Sam
> > > --
> > >
> > >
> > >
> > > Mark Salmon
> > > Cisco Systems Inc
> > > Phone:773-695-8235
> > > Pager:800-365-4578
> > > email: masalmon@cisco.com
> > > Empowering The Internet Generation.
> > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:55 GMT-3