From: Alejandro Cadarso (a.cadarso@xxxxxxxxxxxxxx)
Date: Fri Sep 08 2000 - 14:30:02 GMT-3
For me the distibute-list in works Ok
2503-mad#sh ip ospf dat
OSPF Router with ID (190.19.15.225) (Process ID 200)
Router Link States (Area 0)
Link ID ADV Router Age Seq# Checksum Link count
190.19.15.193 190.19.15.193 804 0x80000006 0x960E 3
190.19.15.225 190.19.15.225 838 0x800000F5 0x9BE6 2
210.10.10.9 210.10.10.9 7 (DNA) 0x800000EB 0x1FAA 1
Summary Net Link States (Area 0)
Link ID ADV Router Age Seq# Checksum
190.1.0.0 210.10.10.9 246 (DNA) 0x80000094 0x95D
190.19.15.224 190.19.15.225 766 0x80000095 0xB27
192.19.18.0 210.10.10.9 246 (DNA) 0x80000093 0x47FA
210.10.10.8 190.19.15.193 804 0x80000002 0xACF6
210.10.10.8 210.10.10.9 11 (DNA) 0x8000009D 0x803A
2503-mad#sh ip ro 190.1.0.0
% Network not in table
Perhaps some misconfigured command or IOS bug.
mark salmon wrote:
>
> II have used the dstributed in with OSPF in the past. At first, the
> route was gone from the routing table. After about 1 minute, the route
> was back.
>
> Geatti wrote:
> >
> > Remember, OSPF sends LSAs not ROUTES so a distribute-list out on an
> > interface is useless.
> > You can use a distribute-list in and this should work for blocking the rout
e
> > from the local router.
> > If this doesn't work for you post your config.
> >
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> > Kenneth Kriel
> > Sent: Friday, September 08, 2000 9:42 AM
> > To: 'Ccielab
> > Subject: OSPF Filtering
> >
> > Gentleman,
> >
> > How do I filter a route from coming into OSFP ? I know it might be a stupid
> > question but I can not get it to work !
> >
> > Layout
> >
> > OSPF Area 1 Area 0
> > 192.2.2.0/24----|
> > |--R1-----R2
> > 135.1.x.0/24----|
> >
> > I do not want to see 192.2.2.0/24 on router R2 !
> >
> > I tried distribute-list out on R1 and in on R2 but no luck !
> >
> > Thank you in advance !
> >
> > Ken
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:54 GMT-3