From: Mark Salmon (masalmon@xxxxxxxxx)
Date: Thu Sep 07 2000 - 22:33:29 GMT-3
No as I said, e? only showed the exit option.
At 12:07 AM 09/07/2000 -0500, Sam Munzani wrote:
>Do you an option for encap SDE?
>
>Sam
>----- Original Message -----
>From: "mark salmon" <masalmon@cisco.com>
>To: <ccielab@groupstudy.com>
>Sent: Thursday, September 07, 2000 1:05 AM
>Subject: Re: Inter Vlan routing and 36xx
>
>
>> Thanks to all who responded. Apparently I was not clear enough. Here is
>> what I did:
>>
>> In config mode I did
>>
>> int fast 0/1.1
>>
>> In sub interface mode I did e? and all I saw was exit.
>>
>> What I asked was did anyone on the list successfully configured inter
>> vlan routing on a 3600 series router as I was unable to find information
>> in the documentation relating to a 3600 router.
>>
>> I am aware that 7xxx router supports inter vlan routing in fast/gig
>> interfaces.
>>
>> Is there someone out there who was able to do it on a 3600 series
>> router?
>>
>>
>>
>> Sam Munzani wrote:
>> >
>> > You have to do following.
>> > If your fastEthernet interface is 1/1 then,
>> >
>> > int fast 1/1.1
>> > encap isl 1 <== Where 1 is VLAN number for the trunk.
>> >
>> > You can't do trunk on main interface.
>> >
>> > Sam
>> > ----- Original Message -----
>> > From: "mark salmon" <masalmon@cisco.com>
>> > To: <ccielab@groupstudy.com>
>> > Sent: Wednesday, September 06, 2000 11:26 PM
>> > Subject: Inter Vlan routing and 36xx
>> >
>> > > Has anyone been able to do inter vlan routin between a cat switch and
>a
>> > > 36xx router with fast eth interfaces? I tried and the one I am using
>> > > (on Vlabs by mentor labs) there is no encap isl command available.
>> > > --
>> > >
>> > >
>> > >
>> > > Mark Salmon
>> > > Cisco Systems Inc
>> > > Phone:773-695-8235
>> > > Pager:800-365-4578
>> > > email: masalmon@cisco.com
>> > > Empowering The Internet Generation.
>> > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:54 GMT-3