From: mark salmon (masalmon@xxxxxxxxx)
Date: Thu Sep 07 2000 - 03:05:04 GMT-3
Thanks to all who responded. Apparently I was not clear enough. Here is
what I did:
In config mode I did
int fast 0/1.1
In sub interface mode I did e? and all I saw was exit.
What I asked was did anyone on the list successfully configured inter
vlan routing on a 3600 series router as I was unable to find information
in the documentation relating to a 3600 router.
I am aware that 7xxx router supports inter vlan routing in fast/gig
interfaces.
Is there someone out there who was able to do it on a 3600 series
router?
Sam Munzani wrote:
>
> You have to do following.
> If your fastEthernet interface is 1/1 then,
>
> int fast 1/1.1
> encap isl 1 <== Where 1 is VLAN number for the trunk.
>
> You can't do trunk on main interface.
>
> Sam
> ----- Original Message -----
> From: "mark salmon" <masalmon@cisco.com>
> To: <ccielab@groupstudy.com>
> Sent: Wednesday, September 06, 2000 11:26 PM
> Subject: Inter Vlan routing and 36xx
>
> > Has anyone been able to do inter vlan routin between a cat switch and a
> > 36xx router with fast eth interfaces? I tried and the one I am using
> > (on Vlabs by mentor labs) there is no encap isl command available.
> > --
> >
> >
> >
> > Mark Salmon
> > Cisco Systems Inc
> > Phone:773-695-8235
> > Pager:800-365-4578
> > email: masalmon@cisco.com
> > Empowering The Internet Generation.
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:53 GMT-3