From: dhbrown@xxxxxxxxxxxx
Date: Wed Sep 06 2000 - 15:47:58 GMT-3
There was a thread on this a while back. If I recall correctly, it is best to
configure the passwords BEFORE activating them on the routing protocol. If you
wait and create the passwords last, you will have the problem you are having.
I just ran it in the lab and it worked, give it a try.
David
(RTP lab 9/18)
aiqun hu <huaq@hotmail.com> wrote:
> I found that every time when I enable authentication on RIP, OSPF and BGP
routing protocol, I had to reconfigure the PWD several times to make it
work. I use notepad to copy and paste with the same authentication mode and
same password on both sides, but always have some problems. Deleted the PWD
on both sides, reconfigured the same PWD again and agin. It works!!!
Anybody ran the same problems like that??? Is there any easiest way to get
success on the first time when configuring the authentication on these
routing protocols? I really want to get rid of these funny problems to save
time.
Thanks in advance for your reply
Rena
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:53 GMT-3