From: Simon Baxter (Simon.Baxter@xxxxxxxxxxxxxx)
Date: Fri Sep 01 2000 - 02:32:15 GMT-3
You'll need to add the keyword [dialer] in
snapshot client active-time quiet-time [suppress-statechange-updates]
[dialer]
to initiate a call in the absence of normal traffic...
Simon
-----Original Message-----
From: Maljure, Sanjay [mailto:smaljure@cibernetworks.com]
Sent: Friday, September 01, 2000 3:28 PM
To: 'Erick B.'; ccielab@groupstudy.com
Subject: RE: Snapshot routing
I remember reading the config guide and it says...
"These entries remain frozen during a quiet period. At the end of the
quiet period, another active period starts during which routing information
is again exchanged."
So snapshot is supposed to make sure that routing entries freeze in the
routing tables during the quiet period.
Actually I am going to try it out in the next couple of hours. Will let u
guys know
Sanjay
-----Original Message-----
From: Erick B. [mailto:erickbe@yahoo.com]
Sent: Friday, September 01, 2000 1:10 AM
To: ccielab@groupstudy.com
Subject: Snapshot routing
Hello,
Have been working on Snapshot routing tonight and
about to hit bed. I got it working and all and my
routes are aging out like normal. Do I need to adjust
the timers to hold the routes in the routing table for
the quiet time (while line is down)? I thought
snapshot would take care of that but maybe I'm
mistakened.
Thanks, Erick
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:51 GMT-3