nlsp single instance on WAN interface.

From: STC Chen Duan (STCCDU@xxxxxxxxxxxx)
Date: Fri Aug 25 2000 - 11:39:38 GMT-3

• Next message: Simon Baxter: "RE: BGP Confederations"
• Previous message: Chad Marsh: "Re: 2nd attempt at a question!!"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
  When I run single nlsp instance with the following configuration.

  r1(s0)----(s1)r2(e0)----(e0)r3

  I find that r1 can learn the route on the ethernet, but r3 can't learn the
route on serial. However, r3 can learn the route of r1's internal network.
If I change the serial connection to ethernet, everything is OK. My question
is, is that true that you just can't find the route on the WAN interface
when you configure nlsp?

  BTW, if I run multi nlsp instances on r2, it's fine. I could see all the
routes.

any comments are appreciated

• Next message: Simon Baxter: "RE: BGP Confederations"
• Previous message: Chad Marsh: "Re: 2nd attempt at a question!!"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:30 GMT-3