From: Simon Baxter (Simon.Baxter@xxxxxxxxxxxxxx)
Date: Tue Aug 22 2000 - 23:18:50 GMT-3
No, only on one side. When you've configured it you can do a show ip os int
at both ends and you'll see it's configd as DEMAND CIRCUIT.
watch the link state for the ppp host route too - I haven't tried it yet but
I know that when ppp comes up a /32 route is installed in the route table as
well as the route for the interface. This generates an LSA. When the ppp
goes down, the /32 is removed creating another LSA which brings the link
back up etc etc etc.
use no neighbor-route command to stop this /32 being generated.
I'm not sure whether this occurs on a spoofing interface or not...will try
in the next few days. If you can try it now, might save me the time!!!
cheers,
Simon
-----Original Message-----
From: Muthu [mailto:muthumon@usa.net]
Sent: Wednesday, August 23, 2000 11:46 AM
To: ccielab@groupstudy.com
Subject: OSPF demand circuit
Hi all,
I am trying some scenarios in ospf demand circuit over isdn.
Can some body tell me whether "ip ospf demand circuit " command is
required
at both side of the ISDN link.
Any help is greatly appreciated.
Thanks
muthu
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:29 GMT-3