netbios host access filter

From: Dezso Csonka (dcsonka@xxxxxxxxx)
Date: Mon Aug 21 2000 - 19:06:37 GMT-3

• Next message: Kent: "Re: NLSP route aggregation"
• Previous message: Andrew: "Re: DCE LMI down"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
I have the following scenario :

vlan10----e0-r1-s0----------s0-r2-e0------vlan1-----NTDEMO-HN-BUD

NTDEMO-HN-BUD is an nt server. I applied the following netbios filters on
r2:

netbios access-list host HAGAR deny NT*
netbios access-list host HAGAR deny nt*
netbios access-list host HAGAR permit *

and i made the dlsw peering with r1 on r2:

dlsw local-peer peer-id 1.1.1.2
dlsw remote-peer 0 tcp 1.1.1.1 host-netbios-out HAGAR

Apart from that the name of the nt server still appears in the sh dlsw re
output. What does the host-netbios-out command filters out then? What can i
use it for?

I also defined some static entries the following way on r1:

dlsw icanreach netbios-name zsuzsi
dlsw icanreach netbios-name jozsi
dlsw icanreach netbios-name feri

How can i prevent them from not appearing on r2 with sh dlsw reachibility?
What filter i should use?

Thanks

• Next message: Kent: "Re: NLSP route aggregation"
• Previous message: Andrew: "Re: DCE LMI down"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:28 GMT-3