Re: ISDN issues - basic-net3

From: Lachlan_Kidd@xxxxxxxxxxxx
Date: Tue Aug 15 2000 - 20:43:28 GMT-3

• Next message: David H. Brown: "Lab Swap - RTP 10/2"
• Previous message: Andy Singh: "enable mode command"
• Maybe in reply to: Vijay Venkatesh: "ISDN issues - basic-net3"
• Next in thread: Simon Baxter: "RE: ISDN issues - basic-net3"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Vijay,
     We use basic-net3 in Aust. No SPIDs are required. When you do a debug
q921, you'll see things like the TEI being assigned and then lots of RR's
and UA's between the switch and router. Q931 shows the connection of a call
proceeding. That is, the number dialled, messages from the switch about the
other end, service types, calling ID etc. Hope this helps.
Regards,
     Lachlan

                    Vijay Venkatesh

                    <vijay.venkates To: ccielab@groupstudy.com

                    h@usa.net> cc:

                    Sent by: Subject: ISDN issues - basic-net
3
                    nobody@groupstu

                    dy.com

                    15/08/00 10:29

                    AM

                    Please respond

                    to Vijay

                    Venkatesh

Hi FOlks,
           QUick question. When using a switch configured for basic-net3
switch-type (european style) I wouldn't need to configure spids right
?
If so what do debugs on q931 nad q921 provide ? Any thoughts on this ?

Regards,
Vijay.

• Next message: David H. Brown: "Lab Swap - RTP 10/2"
• Previous message: Andy Singh: "enable mode command"
• Maybe in reply to: Vijay Venkatesh: "ISDN issues - basic-net3"
• Next in thread: Simon Baxter: "RE: ISDN issues - basic-net3"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:26 GMT-3