From: Brian S turner (brian@xxxxxxxxxxxxxxxxx)
Date: Tue Aug 15 2000 - 11:28:00 GMT-3
If you are talking about a lab situation. You will be allowed to move
your console cable around so plug into the console port of the router
with you console cable and change you speed to 1200 and then make the
change, and reconnect the routers.
If you are talking about real life, and you don't have physical access
to the router. there are rxspeed and txspeed commands under the line
config, but you will have to make sure to disconnect and re-connect
the line after changing its speed.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
qq
Sent: Sunday, August 13, 2000 9:45 PM
To: ccielab@groupstudy.com
Subject: how to change the reverse telnet line speed to ???
hi,
r1-----r2
r1 is a 2501 , and r2 is a 2509, they are connected by asyn lines.
i use reverse telnet to control r1, now the r1's console speed is set
to 1200 bits, not 9600bits, how to change the termal line speed ar r2
, so that i can control r1.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:26 GMT-3