From: Mike Hess (mahess@xxxxxxxx)
Date: Sun Aug 06 2000 - 23:05:24 GMT-3
When you set the community to no-export, the route will be stripped from any
ebgp update. Use a numeric community along with the neighbor x.x.x.x
send-community command and you should see something.
Mike
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> damien
> Sent: Sunday, August 06, 2000 1:26 PM
> To: Earl Aboytes; ccielab@groupstudy.com
> Subject: Re: bgp community
>
>
> Have you specified the community with "ip communtity"command and
> I don't see
> the "neighbor x.x.x.x send-community" also
>
> ----- Original Message -----
> From: "Earl Aboytes" <earl@linkline.com>
> To: <ccielab@groupstudy.com>
> Sent: Friday, August 04, 2000 7:04 AM
> Subject: bgp community
>
>
> > I am sending a community to my neighbor but I am not seeing the
> community
> > with a sh ip bgp community at the neighbor.
> >
> > I have two routers that are neighbored. One in AS7 and the
> other in AS 25
> > I have a route-map that matches on all addresses and set the
> community to
> > no-export.
> > When I go to the neighbor and do a sho ip bgp community I cannot see
> > anything.
> >
> > access-list 35 permit any
> > route-map setcomm permit 10
> > match ip address 35
> > set community no-export
> > router bgp 7
> > neighbor 138.7.2.254 route-map setcomm out
> >
> > Any ideas?
> >
> > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> > Earl Aboytes
> > Senior Technical Conultant
> > GTE Managed Solutions
> > 805-381-8817
> > earl.aboytes@verizon.com
> > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> >
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:22 GMT-3