From: Earl Aboytes (earl@xxxxxxxxxxxx)
Date: Thu Aug 03 2000 - 14:13:13 GMT-3
You can assign anything you want :)
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Earl Aboytes
Senior Technical Conultant
GTE Managed Solutions
805-381-8817
earl.aboytes@telops.gte.com
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Ron.Fuller@3x.com
Sent: Thursday, August 03, 2000 9:53 AM
To: Hank Leung
Cc: ccielab@groupstudy.com
Subject: Re: Ring Number
Maybe I needed to be more clear. If this is a new router being installed
into a SRB environment, how do I know what ring number to assign the
interface BEFORE I configure the router and do a not shut on the interface.
TIA!
Ron Fuller, CCIE #5851, CCDP, CCNP-ATM, CCNP-Security, MCNE
3X Corporation
rfuller@3x.com
"Hank Leung"
<hank1979@hot To: Ron.Fuller@3x.com
mail.com> cc: ccielab@groupstudy.com
Subject: Re: Ring Number
08/02/00
03:23 PM
Show source-bridge <interface> should give you the SRNs, BNs, and TRNs. If
you set two bridges with different ring numbers you will get an error. The
first one will be created, but the second one will give you an error.
Something like invalid ring number, mismatch or something..
>From: Ron.Fuller@3x.com
>Reply-To: Ron.Fuller@3x.com
>To: ccielab@groupstudy.com
>Subject: Ring Number
>Date: Wed, 2 Aug 2000 14:27:57 -0400
>
>When configuring SRB on a token ring interface in a production network,
how
>can you tell what the ring number is? Are there any debugs that will show
>you this info? What would happen to the network if the same ring had two
>bridges on it that gave different ring numbers? I poked around on CCO for
a
>bit, but didn't see anything obvious.
>
>I imagine that you could use a sniffer to read the RIF, but any other
>ideas.
>
>TIA
>Ron Fuller, CCIE #5851, CCDP, CCNP-ATM, CCNP-Security, MCNE
>3X Corporation
>rfuller@3x.com
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:20 GMT-3