From: Simon Baxter (Simon.Baxter@xxxxxxxxxxxxxx)
Date: Thu Aug 03 2000 - 03:44:06 GMT-3
Sounds like a typo - are you sure it's selected as the default (with a
*) and originated from a distance vector protocol?
Is it any different with : default-information originate
route-map checkit 'always'
Sorry if I'm telling what to 'do with eggs'!!
Simon Baxter
-----Original Message-----
From: Fred Nielsen [mailto:fred_nielsen@hotmail.com]
Sent: Thursday, August 03, 2000 1:02 PM
To: ccielab@groupstudy.com
Subject: OSPF, def. origin. & route-maps
Has anyone successfully been able to use the ospf 'default-information
originate route-map blah' command? I'm trying to selectivity have an
OSPF ASBR inject a default route into OSPF based on the presence of an
entry in the routing table. Something like
:router ospf 1
: default-information originate route-map checkit
:
:route-map checkit permit 10
: match ip address 1
:
:access-list 1 permit 192.168.1.0 0.0.0.255
The 192.168.1.0/24 route exists in this router's local routing table
(originating from RIP BTW) but no default is generated. The only way
I've been able to generate a default is to clear the route-map's match
commands, so essentially everything matches. I must have the syntax
wrong for this. I found an example on CCO very similar to what I'm
trying to do here
(http://www.cisco.com/cgi-bin/Support/OpenForum/dispnewqa.pl/5605) but
I can't seem to get it to work right.
------
Fred Nielsen [fred_nielsen@hotmail.com]
------
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:20 GMT-3