From: Brian Hescock (bhescock@xxxxxxxxx)
Date: Tue Aug 01 2000 - 20:35:57 GMT-3
Bob brings up a good point below. One thing I was uncertain with after my
reply (and even mentioned to a colleague also on the list) was that
offset-list might only be supported in ip rip, not ipx rip. I looked up
the command reference and that appears to be the case and I just tried it
in a router in the lab (only worked under router rip, not an option with
ipx router rip).
Brian
On Tue, 1 Aug 2000, Bob Reed wrote:
> However, if you prepend 5 to all hop counts, then they hit max at 10 + 5
> instead of 15. So doesn't this make the max hop count 10?
>
> Bob Reed
>
>
> ----- Original Message -----
> From: "Brian Hescock" <bhescock@cisco.com>
> To: "Johnny Dedon" <jdedon@cohesive.com>
> Cc: <ccielab@groupstudy.com>
> Sent: Tuesday, August 01, 2000 4:09 PM
> Subject: Re: increasing ipx hop count
>
>
> > offset lists basically allow you to pad one route so it will take another
> > path instead. Kind of like bgp and using the prepend command so you make
> > one as-path longer than the other.
> >
> > B.
> >
> > On Tue, 1 Aug 2000, Johnny Dedon wrote:
> >
> > > Guys,
> > > A few days ago someone was asking about changing the ipx hop count. I
> found
> > > a command called offset-list under the rip router configuration that
> allows
> > > you to increase(offset) the hop count. I think it only allows you to
> > > increase it however.
> > >
> > > Johnny
> > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:20 GMT-3