From: mark salmon (masalmon@xxxxxxxxx)
Date: Tue Jul 25 2000 - 13:46:08 GMT-3
Thanks for all who responded. I am still confused by this command. DOes
it means the router that this command is run on will advertise itself as
a default router to peers in the OSPF domain? If so I fully understand
it. IF not, then can someone explain how that command works?
Andres Zeller wrote:
>
> Default origniate always.
>
> mark salmon wrote:
> >
> > Can someone give me an example on how to configure a default route
> > (without using static routes) on an OSPF router?
> >
> > "Aaron K. Dixon" wrote:
> > >
> > > Step 10 says to create a default route to that router so that all ospf
> > > routers see it. I assume he wants you to advertise the default route whi
ch
> > > will then allow a ping of that network. If you don't have a route for th
at
> > > subnet it will take the default route which resides on the router with th
e
> > > loopback that you configured.
> > >
> > > Regards,
> > > Aaron K. Dixon
> > >
> > > -----Original Message-----
> > > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> > > mark salmon
> > > Sent: Tuesday, July 25, 2000 12:16 AM
> > > To: ccielab@groupstudy.com
> > > Subject: CCbootcamp
> > >
> > > Hey guys, I was reading the following practice lab at ccbootcamp.com and
> > > I ran into a scenario which puzzled me. Take a look at item 11 under
> > > task 3. Does anyone know how to make a route/address reachable without
> > > having that address/route be placed in a routing table? I am assuming
> > > it is asking us to make this address reachable without using static
> > > routes. Does anyone else concur?
> > >
> > > http://www.ccbootcamp.com/samplelab.htm
> > > --
> > >
> > > Mark Salmon
> > > Project Engineer
> > > Cisco Professional Services
> > > Phone:773-695-8235
> > > Pager:800-365-4578
> > > email: masalmon@cisco.com
> > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:58 GMT-3