testing SR/TLB...

From: Alexandre M. S. P. Moraes (amoraes@xxxxxxxxx)
Date: Tue Jul 18 2000 - 01:17:19 GMT-3

   
In the following scenario, R2 is acting as a source-route translational
bridging, and R1 and R3 as "clients" on ethernet and token ring sides of
R2 respectively...
   [R1]<-token ->[R2]<-ethernet->[R3]

How can I test whether R2 is working properly ? Is it possible to use IP
? ( for example to put R1's token 0 and R3's e0 in the same IP logical
subnet ? )
The configs are sent below...
I do hope you can help me with this.
My best regards,
     Alexandre

R2:

bridge 4 protocol ieee
source-bridge ring group 200
source-bridge transparent 200 13 1 4
 int token 0
    ring-speed 16
    source-bridge 500 1 200
    source-bridge spanning
int ethernet 0
    bridge-group 4

If possible to use IP, what should be added to the following configs in
order to have this configurationn working ?
R1:
int token 0
   ip add 10.0.0.1 255.0.0.0
   ring-speed 16

R3:
int ethernet 0
   ip address 10.0.0.2 255.0.0.0

( If it's not possible using IP what would be an option to test the
SR/TLB operation with the three routers ? ) 

--
*******************************************************************
  Cisco Systems
  Empowering the Internet Generation

  Alexandre M. S. P. Moraes
  Systems Engineer
  Cisco do Brasil-Brasília Office
  SCN Q5 - Bloco A - Torre Sul - Sala 1016
  C. E. Brasília Shopping - CEP: 70710-500
  Brasília-DF-Brazil
  Phone:(55-61)328-5397
  FAX:(55-61)327-2236  Cellular: (55-61)9967-6311
  Pager: 0800-999888(in Brazil) or 5521-5431438(international)
         or  http://www.teletrim.com.br
         code: 4243702
*******************************************************************

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:54 GMT-3