From: Kevin Baumgartner (kbaumgar@xxxxxxxxx)
Date: Wed Jul 05 2000 - 22:53:48 GMT-3
It's works exactly the same as a 2511 commserver. The only difference
is that the vty ports start at 32 and up. This confused me the first time
I used it.
Kevin
>
> Chidi,
>
> I had the same thing happen on a 3620. TAC replaced it DOA. Kind of funny,
> it was working one week, went to re-config. it a couple of weeks later and
> no go. Got through most of the bootup and just hung. Could get into rommon
> mode and tried a few different settings but nothing helped.
>
> --Alan
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Sullivan, Mark
> Sent: Tuesday, July 04, 2000 8:36 PM
> To: 'CHIDI FRANCIS'; CCIELAB@groupstudy.com
> Subject: RE: Console problem
>
> Chidi
>
> This is not a router issue but a terminal emulation problem. The console
> port of the router does not support flow control and as a result you must
> disable flow control on your terminal emulator (the default for
> hyperterminal is "HARDWARE").
>
> The symptom, you can see console output but the router will not accept any
> keystokes, including control-break.
>
> I see this problem often. I find some router/PC combinations are more
> sensitive to this issue than others.
>
> Regards
>
> Mark Sullivan
>
> -----Original Message-----
> From: CHIDI FRANCIS [mailto:eejiofor@yahoo.com]
> Sent: Wednesday, July 05, 2000 3:42 AM
> To: CCIELAB@groupstudy.com
> Subject: Console problem
>
>
> I need help so bad. I have 2509 connected to my pc through the console port
> and to other 7 routers through an octal cable. Never had any problem till
> yesterday when I cannot access the router through the connsole port.
> Consequently, I do not have access to the other 7 routers. Have any member
> had this problem before. I have checked and cross checked literally every
> things and it looks ok. I have tried connecting same cable to another router
> and it works fine--it accepts command from the key board, however, when I
> connect to to this problem router it doesn't not accept commands from key
> board. I have tried reload, I can see the output but router does not accept
> command from the key board. My last effort was to issue a break key and then
> to > prompt, that works because the router did accept commands typed. When I
> reload and issue and command or enen hit my ENTER key, no response from the
> router. Is this router in comma or dead forever, Any help will be highly
> appreciated.
>
> CHi
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:52 GMT-3