From: Cliff Stewart (cliffstewart@xxxxxx)
Date: Mon Jul 03 2000 - 01:22:23 GMT-3
Chandra,
I assume you are you have the appropriate cable-ranges and zones applied to the
interfaces? Did you confirm that you could ping both ends of the circuit?
Example: appletalk cable-range 100-100 100.1<---Host
appletalk zone ccietunnel
After you verify these things, issue a debug appletalk packet. If your still st
uck, post the entire configs from both routers. Hope this helps.
Cliff
-----Original Message-----
From: "Chandra Lingamgunta"<lcsekhar@bigfoot.com>
To: ccielab@groupstudy.com
Date: Sun Jul 02 20:21:28 PDT 2000
Subject: AURp problem
>Hi all,
>I just tried AURP tunnel. I could see routing updates(additional routing entri
es int the table) on one side of the tunnel, but the other side router is not g
etting any updates. And also I can't ping the nodes. The config I uses was:
>
>tunn 0
>app pro aurp
>tunn source 10.2.1.1
>tunnel dest 10.2.1.2
>tunn mode aurp.
>
>This is the kind of config I had on either side. Any thing that I am missing?
>Regards
>Chandra
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:52 GMT-3