ISIS route filtering

From: Clifton Stewart (cliftonlstewart@xxxxxxxx)
Date: Thu Jun 29 2000 - 13:21:22 GMT-3

• Next message: Chris Kirschke: "Request"
• Previous message: Vijaykrishna: "ISIS route filtering"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hi Vijay,

CLNS uses filter-sets opposed to distribute-lists and you need to deny
the NSAP address. If you were using and IP based protocol an
access-group would apply the list to the interface. In the case of ISIS
the
clns access-group command applies the filter-set to the interface.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios113ed/113ed_cr/np1_
c/1cisis.htm

Clifton Stewart-CCNA, CCIE Candidate

Vijaykrishna wrote:
>
> Hi all,
>
> How to filter routes in ISIS.
> I tried distribute-list and surprisingly the command does not show up in the
> config.
>
> -vijay
>

• Next message: Chris Kirschke: "Request"
• Previous message: Vijaykrishna: "ISIS route filtering"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:44 GMT-3