From: Saleem Rahman (srahman@xxxxxxxxxx)
Date: Sun Jun 25 2000 - 15:29:26 GMT-3
Ron & kongck,
Thats an great idea.......
I tried your method specified ... It works..
Thank you very much !
Regards,
Saleem
> -----Original Message-----
> From: Ron.Fuller@3x.com [SMTP:Ron.Fuller@3x.com]
> Sent: Sunday, June 25, 2000 8:06 PM
> To: Saleem Rahman
> Cc: ccielab@groupstudy.com; nobody@groupstudy.com
> Subject: Re: IPX SAP QUESTION
>
>
> You can create a tunnel between R1 and R3, going through R2. This would
> allow the IPX SAP to be carried unknown to R2. Then on R1 and R3 serial
> interfaces create your IPX Output SAP Filter. The filters would keep the
> SAP from being propogated to R2. Long way to go to reach a goal, but
> that's what jumps to mind first for me.
>
> HTH
> Ron Fuller, CCIE #5851, CCDP, CCNP-ATM, CCNP-Security, MCNE
> 3X Corporation
> rfuller@3x.com
>
>
>
>
> Saleem Rahman
>
> <srahman@luce To: ccielab@groupstudy.com
>
> nt.com> cc:
>
> Sent by: Subject: IPX SAP QUESTION
>
> nobody@groups
>
> tudy.com
>
>
>
>
>
> 06/25/00
>
> 08:39 AM
>
> Please
>
> respond to
>
> Saleem Rahman
>
>
>
>
>
>
>
>
>
> Hi All,
> I am facing a problem to support a IPX SAP question......unable to find
> the
> answer.
>
> The scenario as follows.
>
> Q. R1 is advertising a Static SAP entry to downstream routers.....Using
> IPX
> SAP filter only 'R2' should NOT see in the entry in is SAP table, but R3
> should be able to see it.
>
> IPX RIP all over.
>
> eth serail serial eth
> ---- R1--------|-------R2--------|------R3---
>
> Note : I tried to configure 'ipx input-sap filter' / '
> ipx-router-sap-filter' (Also, tried configuring IPX EIGRP on the serial
> links and used "distribute-list filtler"). It gets blocked at the R2 and
> eventually never gets propagaed to R3.
>
> Is there any other method to accomplish this scenario.
>
> Any kind of tips or helps will highly appreciable.
>
> Thanks in advance.
>
> Regards,
> Saleem
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:43 GMT-3