From: Goh, Winston (winston.goh@xxxxxxxxxxxxx)
Date: Fri Jun 16 2000 - 08:04:42 GMT-3
Hi,
i am trying to get IRB to work. Here is the scenario :
r5(ether0)-----(ether0)r2(serial0)------(serial1)r3
What i am trying to do :
Disable ipx on r2, but r5 ethernet and r3 is configure with ipx. This
scenario in fact is similar to what we have in bootcamp 8b. but i just can't
ping any ipx networks from r5 to r3. Can someone give me an advice ? Below
is my config :
r3:
interface Serial1
ip address 132.10.32.1 255.255.255.0
no logging event subif-link-status
appletalk cable-range 302-302 302.3
appletalk zone r3r2serial
bridge-group
interface BVI1
no ip address
no logging event subif-link-status
ipx network 3005
bridge irb
bridge 1 protocol ieee
bridge 1 route appletalk
bridge 1 route ip
bridge 1 route ipx
no bridge 1 bridge appletalk
no bridge 1 bridge ip
r2:
interface Ethernet0
ip address 132.10.25.1 255.255.255.0
appletalk cable-range 205-205 205.2
appletalk zone ether
bridge-group 1
!
interface Serial0
ip address 132.10.32.2 255.255.255.0
appletalk cable-range 302-302 302.2
appletalk zone r3r2serial
no fair-queue
clockrate 2000000
bridge-group 1
r5:
interface Ethernet0
backup delay 10 10
backup interface BRI0
ip address 132.10.25.5 255.255.255.0
appletalk cable-range 205-205 205.5
appletalk zone ether
ipx network 3005
bridge-group 1
Winston Goh
CCNP, CVE
Snr Network Specialist
Unisys Singapore
mobile : 97469192
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:42 GMT-3