From: Ryan B (rbenigno@xxxxxxxx)
Date: Wed Jun 07 2000 - 11:13:47 GMT-3
And how does your EIGRP topology table look? Do you actually have the
routes? You need to either adjust the timers and leave EIGRP as interesting
traffic (dialer hold-queue is nice too) or use floating static's to get this
working properly...
-Ryan
----- Original Message -----
From: "Lekan Magbagbeola" <lekkyl@hotmail.com>
To: <lister@kruepke.com>; <abdul_rahim@ccsi.canon.com>;
<ccielab@groupstudy.com>
Sent: Wednesday, June 07, 2000 3:06 AM
Subject: Re: DDR config with EIGRP and OSPF
> Keith,
>
> Well, I disagree with you on the issue of EIGRP. I have configured DDR
with
> EIGRP and it worked! All you have to do is configure your dialer-list not
to
> see the following as interesting;
>
> 1. traffic going from the BRI interface to host 224.0.0.10
> 2. EIGRP traffic going from one BRI interfaces to the other
>
> Any other traffic as interesting!
>
> Try it, this should work.
>
>
> Lekan
>
>
>
> >From: "Kruepke" <lister@kruepke.com>
> >Reply-To: "Kruepke" <lister@kruepke.com>
> >To: <abdul_rahim@ccsi.canon.com>, <ccielab@groupstudy.com>
> >Subject: Re: DDR config with EIGRP and OSPF
> >Date: Tue, 6 Jun 2000 20:33:43 -0500
> >
> >Abdul,
> >
> >EIGRP cannot do DDR. The necessity of the Hellos prevents it.
> >
> >OSPF uses a feature called Demand Circuit to do DDR. I don't have any
> >configs handy, but all you need to do is enter the 'ip ospf
demand-circuit'
> >in interface configuration mode. It only needs to be done to one side of
> >the link. With this, your LSAs from across the link should be marked DNA
> >(do not age) in the link state database, and your demand circuit neighbor
> >should not have a hold timer.
> >
> >Regards,
> >Keith
> >
> >----- Original Message -----
> >From: <abdul_rahim@ccsi.canon.com>
> >To: <ccielab@groupstudy.com>
> >Sent: Tuesday, June 06, 2000 3:52 PM
> >Subject: DDR config with EIGRP and OSPF
> >
> >
> >Hi Can any body forward me some DDR configs with EIGRP
> >Thanks
> >Abdul
> >
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:41 GMT-3