From: Joe Martin (jmartin@xxxxxxx)
Date: Tue Jun 06 2000 - 00:03:49 GMT-3
Here's the deal with AURP tunnels. You cannot appletalk ping from a router
that has an aurp tunnel to a destination across that tunnel. This is due to
the unnumbered nature of this type of interface and the fact that there
isn't a way to specify a a source interface for appletalk pings.
JOE
CCIE 5917
----- Original Message -----
From: "Brian Hescock" <bhescock@cisco.com>
To: "Bill Dellamar" <wdellamar@yahoo.com>
Cc: "Rene Mendoza" <rene.mendoza@sabre.com>; <ccielab@groupstudy.com>
Sent: Monday, June 05, 2000 6:07 PM
Subject: Re: Appletalk without cable range command
> I was able to do it also, if I remember correctly. I don't have my
> current configurations but I was following the labs in the "All-in-One
> CCIE Lab Study Guide" and I took the GRE tunnel one step further and
> modified it to be an AURP tunnel instead (if all you do is the basic labs
> I doubt you will pass the CCIE lab). I could be mistaken but I'm quite
> sure it worked just fine. If everyone thinks I'm full of it (no
> wisecracks Dave G...;-), I'll set it up again and see if I can reproduce
> it. I can't remember if that's the week I was drinking heavily... ;-)
>
> Brian
>
>
> On Mon, 5 Jun 2000, Bill Dellamar wrote:
>
> > how about posting your configs.
> > thanks,
> >
> > --- Rene Mendoza <rene.mendoza@sabre.com> wrote:
> > > I was able to APPLE ping through the aurp tunnel. I
> > > was pinging a network
> > > on the other side of the tunnel and it worked just
> > > fine.
> > >
> > > pbosio@comtech.com.au wrote:
> > >
> > > > Don't forget that your APPLE ping will NOT work
> > > through the tunnel..
> > > >
> > > > Use Aurp tunnel , you can do it
> > > > regards
> > > > xihan wang
> > > > ----- Original Message -----
> > > > From: Pard Mahatthanatrakul <pardm77@yahoo.com>
> > > > To: ccie <ccielab@groupstudy.com>
> > > > Sent: Thursday, June 01, 2000 1:13 AM
> > > > Subject: Appletalk without cable range command
> > > >
> > > > > Hi everyone,
> > > > >
> > > > > Just wonder how can I enable appletalk on the
> > > tunnel
> > > > > interface without using cable range command?
> > > Does
> > > > > "apple protocol aurp" will do the trick? What
> > > else
> > > > > that I miss?
> > > > >
> > > > > Your comments are greatly appreciated.
> > > > >
> > > > > TIA
> > > > >
> > > > > Pard
> > > > >
> > > > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:40 GMT-3