From: Chia Kim Seng, Sr Network Spec, SCS-Networks (chiaks@xxxxxxxxxxxxxxxxxxxxxx)
Date: Wed May 31 2000 - 20:41:54 GMT-3
Yes, using aurp tunnel will enable the tunnel interface without using cable
range and cable zone command.
Beside 'apple protocol aurp', you must set the tunnel mode to 'aurp' and at
the global config must enable 'appletalk route-redistrubution'
-----Original Message-----
From: Pard Mahatthanatrakul [mailto:pardm77@yahoo.com]
Sent: Thursday, June 01, 2000 1:13 AM
To: ccie
Subject: Appletalk without cable range command
Hi everyone,
Just wonder how can I enable appletalk on the tunnel
interface without using cable range command? Does
"apple protocol aurp" will do the trick? What else
that I miss?
Your comments are greatly appreciated.
TIA
Pard
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:32 GMT-3