From: Roger Wang (rwang@xxxxxxxxxxx)
Date: Mon May 29 2000 - 14:23:05 GMT-3
Well, I don't know what that line does, either. :) It comes up automatically
only with IOS 12.0. I usually make it go away by entering "defau ip ospf
interface-retry" at the interface config mode.
Anyway, I reconfigured the route-map with "match ip addr 101" instead, and
put "permit ip any host x.x.x.x" in the ACL and that fixed the problem. I
still can't figure out why the first method didn't work. It probably has
something to do with the standard access-lists in which source IP addresses
are listed. And I tried to ask route-map to interpret them as "next-hop"
and that confused the routing process. But it's probably just the user.
Rog
> -----Original Message-----
> From: Kevin M. Woods [mailto:kev@nil.org]
> Sent: Sunday, May 28, 2000 9:18 PM
> To: Roger Wang
> Cc: ccielab@groupstudy.com
> Subject: Re: Virtual Link and Route-Map
>
>
> Roger,
>
> I'm trying to figure out what `ip ospf interface-retry' is. Can you share
> your wisdom as to what this does and if/where it's documentated?
>
> Thanx
>
> Kevin
>
> // Hi, all,
> //
> // I have a policy applied on s1 of r3, like so:
> //
> // ======================================
> // !
> // interface Serial1
> // ip address 10.34.1.1 255.255.0.0
> // no ip directed-broadcast
> // ip ospf interface-retry 0
> // ip policy route-map lab1
> // clockrate 2000000
> // !
> // ======================================
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:32 GMT-3