From: Earl Aboytes (earl@xxxxxxxxxxxx)
Date: Thu May 25 2000 - 22:42:21 GMT-3
How do I get a member on that port? Do I have to do a static join?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Earl Aboytes
Senior Technical Conultant
GTE Managed Solutions
805-381-8817
earl.aboytes@telops.gte.com
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of Kevin
M. Woods
Sent: Thursday, May 25, 2000 5:45 PM
To: Earl Aboytes
Cc: ccielab@groupstudy.com
Subject: Re: permanent multicast cam entry
The static CAM entry will allow the switch to forward mulitcast frames out
a specific port, but ping will not get any response unless there's a group
member attached to that port.
Sorry if this is not what you're asking...
Kevin
// I configured a permanent entry in my cam table. I was hoping that I
could
// ping it from my other routers. I am running pim dense mode at the
attached
// routers and I have an ip igmp join-group command on the router for a
// different multicast address that I can ping from my other routers. I am
// also running cgmp at the switch. Should this work?
//
// ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
// Earl Aboytes
// Senior Technical Conultant
// GTE Managed Solutions
// 805-381-8817
// earl.aboytes@telops.gte.com
// ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:31 GMT-3