From: Joe Martin (jmartin@xxxxxxx)
Date: Sat May 13 2000 - 00:35:36 GMT-3
Do you have redistribution taking place somewhere in this network? If you
do, you may have a redistribution feedback occuring. When that occurs, LSAs
are generated and the demand circuit will come up. This will continue to
happen over and over till the end of time. Setup tight distribute-lists or
route-maps to stop this.
JOE
----- Original Message -----
From: "tok cok" <tokcok@hotmail.com>
To: <ccielab@groupstudy.com>
Sent: Friday, May 12, 2000 7:28 PM
Subject: OSPF demand circuit
> Hi,
> I thought using ospf demand-circuit will keep the line quiet but seem it
is
> not.
>
> Below is the routers' configuration, R5 and R6. Demand-circuit is used on
> the ISDN link. But the ISDN line keeps going up due to the multicast
> traffic ( I did a show dialer packet).
>
> Can anyone help me in this? Did I miss out anything to make the demand
> circuit
> works?
>
> Router 6
> interface BRI0
> ip address 137.20.224.6 255.255.240.0
> encapsulation ppp
> ip ospf demand-circuit
> dialer idle-timeout 10
> dialer map ip 137.20.224.5 name R5 broadcast 5552000
> dialer-group 1
> no cdp enable
> ppp authentication chap
> !
> !
> dialer-list 1 protocol ip permit
> !
>
>
> Router 5
> interface BRI0
> ip address 137.20.224.5 255.255.240.0
> encapsulation ppp
> dialer idle-timeout 10
> dialer map ip 137.20.224.6 name R6 broadcast
> dialer-group 1
> no cdp enable
> ppp authentication chap
> !
> !
> dialer-list 1 protocol ip permit
> !
>
>
>
> deb dialer packet
> BRI0: ip (s=137.20.224.6, d=224.0.0.5), 84 bytes, interesting (ip PERMIT)
> BRI0: sending broadcast to ip 137.20.224.5
> %ISDN-6-DISCONNECT: Interface BRI0:1 disconnected from 5552000 R5, call
> lasteds
> %LINK-3-UPDOWN: Interface BRI0:1, changed state to down
> %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed state to
> down
> BRI0: ip (s=137.20.224.6, d=224.0.0.5), 84 bytes, interesting (ip PERMIT)
> BRI0: sending broadcast to ip 137.20.224.5 -- failed, not connected
> %LINK-3-UPDOWN: Interface BRI0:1, changed state to up
> BRI0: ip (s=137.20.224.6, d=224.0.0.5), 84 bytes, interesting (ip PERMIT)
> BRI0: sending broadcast to ip 137.20.224.5
> %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed state to
up
> %ISDN-6-CONNECT: Interface BRI0:1 is now connected to 5552000 R5
> %ISDN-6-DISCONNECT: Interface BRI0:1 disconnected from 5552000 R5, call
> lasteds
> %LINK-3-UPDOWN: Interface BRI0:1, changed state to down
> BRI0: ip (s=137.20.224.6, d=224.0.0.5), 84 bytes, interesting (ip PERMIT)
> BRI0: sending broadcast to ip 137.20.224.5 -- failed, not connected
> %LINK-3-UPDOWN: Interface BRI0:1, changed state to up
> BRI0: ip (s=137.20.224.6, d=224.0.0.5), 84 bytes, interesting (ip PERMIT)
> BRI0: sending broadcast to ip 137.20.224.5
> BRI0: ip (s=137.20.224.6, d=224.0.0.5), 64 bytes, interesting (ip PERMIT)
> BRI0: sending broadcast to ip 137.20.224.5
> BRI0: ip (s=137.20.224.6, d=224.0.0.5), 64 bytes, interesting (ip PERMIT)
> BRI0: sending broadcast to ip 137.20.224.5
> %ISDN-6-CONNECT: Interface BRI0:1 is now connected to 5552000 R5
> BRI0: ip (s=137.20.224.6, d=224.0.0.5), 64 bytes, interesting (ip PERMIT)
> BRI0: sending broadcast to ip 137.20.224.5
> BRI0: ip (s=137.20.224.6, d=224.0.0.5), 84 bytes, interesting (ip PERMIT)
> BRI0: sending broadcast to ip 137.20.224.5
> %ISDN-6-DISCONNECT: Interface BRI0:1 disconnected from 5552000 R5, call
> lasteds
> %LINK-3-UPDOWN: Interface BRI0:1, changed state to down
> %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed state to
> down
> BRI0: ip (s=137.20.224.6, d=224.0.0.5), 84 bytes, interesting (ip PERMIT)
> BRI0: sending broadcast to ip 137.20.224.5 -- failed, not connected
> %LINK-3-UPDOWN: Interface BRI0:1, changed state to up
> BRI0: ip (s=137.20.224.6, d=224.0.0.5), 84 bytes, interesting (ip PERMIT)
> BRI0: ip (s=137.20.224.6, d=224.0.0.5), 84 bytes, interesting (ip PERMIT)
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:29 GMT-3