From: wang xihan (wangxh@xxxxxxxxxxxxxx)
Date: Thu May 11 2000 - 01:46:14 GMT-3
Hi
Thank you for you reply
I mean when you change the priority to 0, you still can see other nei when you
use
show ip ospf nei , How can i managee to make R3(DR) can see all the nei and r1,
r2 can only see r3
Thanks
xihan wang
----- Original Message -----
From: Kevin Young <kvyoung@sina.com>
To: wang xihan <wangxh@nts.net.edu.cn>
Cc: ccielab <ccielab@groupstudy.com>
Sent: Thursday, May 11, 2000 12:07 PM
Subject: Re: ospf challenge
> try to change the r1 and r2's ethernet interfaces' priority to zero.
> ip ospf pri 0
>
>
>
>
> **************************************
> Kevin Young
> Senior Network Engineer
> Yinxi Electronic Information Co.,Ltd
> (86)-10-82625798 x 810
> **************************************
>
> ----- Original Message -----
> From: wang xihan
> To: kongck ; ccielab@groupstudy.com
> Sent: Thursday, May 11, 2000 10:49 AM
> Subject: ospf challenge
>
>
> Hi all
> Thank you for the reply , i think i get it.
> Here is another quesion.
> In a ethernet ospf area , There are three router connect to each other(r1
,r2,r3), For security reasons, I would like r3 to be the DR, and all router wil
l adjacent to R3 and will not make adjacent to others, That means when i show i
p ospf nei in other routers, only r3 can see r1 and r2, in either r1 and r2 , t
hey can only see r3. There should be some thing can do it.Can sb tell me how?
> Thanks a lot
> xihan wang
>
>
>
>
>
>
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:28 GMT-3