From: Brad Johnson (bjohnson@xxxxxxxxxxxxxx)
Date: Sat May 06 2000 - 22:28:41 GMT-3
i have 4 routers in the backbone. They are connected via frame relay,
without inverse arp. Also i am using multipoint sub interfaces on one
spoke and the hub and the 3 other spokes are using major interfaces.
Connectivity is fine through the use of frame map statements. My
question is this:
I have 2 routers running 11.2.15p and 2 running 12.0.9. I am defining
on the hub, neighbor statements (not allowed to use ip ospf network
commands - NON - BROADCAST INTERFACE TYPE). This seems to work fine in
the beginning but the 11.2 routers seem to drop all ospf routes. It
will form an adjacency, but dies. If you put the ip ospf network
command on it will then work. Also, if you remove ospf, and add it
back to all the routers, it works again under the non-broadcast. Has
anyone seen this before?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:27 GMT-3