From: zhuhai@xxxxxxxxxx
Date: Fri May 05 2000 - 07:09:02 GMT-3
Hi, all
See senario below :
R1---R2---R3 , IPX Routing everywhere , R1 generate network " ab01 ,
cc00, a501,..." to R2 and R3 , to filter IPX Network and only allow
a500-a5ff to be advertised into R2 and R3 , I write bellow : " access 810
permit a500.0000.0000.0001 00ff.ffff.ffff.ffff " and apply it to the R2 ' s
serial port which is connected to the R1's Serial port , by the command "
in s0 , ipx input-network-filter 810 " . But it did not work .
I think the writing format of the access-list must be wrong , but what is
the correct one ?
Thank you !
Regards ,
Colin Zhu
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:27 GMT-3