From: Hedlund, Brad (BHedlund@xxxxxxxxxxxx)
Date: Mon Apr 24 2000 - 11:42:12 GMT-3
The diagram on the left is correct. Connect the E to E and the M to M.
Refer to the following document for details:
http://www.cisco.com/warp/customer/788/21.html
<http://www.cisco.com/warp/customer/788/21.html>
Brad Hedlund
Sr. Network Engineer
CCIE #5530
REAL Solutions, Elcamino Resources Ltd.
Eden Prairie, MN.
(952) 829-2877
-----Original Message-----
From: zheng jiang gu [mailto:zjgu@ce-air.com]
Sent: Sunday, April 23, 2000 11:02 PM
To: Zhong Rujun; luojian; Li Hanzhong; Lee, Vaughan; Hedlund, Brad;
Chien-shun Chu; Brad Hedlund; ccielab
Subject: E&M pins?
hi everyone:
The hicom pbx type 1 give me the pin of the pbx:
1 T1
2 R1
9 T
10 R
17 E
18 M
THE CISCO E&M PORT PIN LIST BELOW:BM_10371
Signal---4-Wire Signal---2-Wire
1
SB (signal battery)
SB (signal battery)
2
M-lead
M-lead
3
Ring (input)
-
4
Ring1 (output)
Ring
5
Tip1 (output)
Tip
6
Tip (input)
-
7
E-lead
E-lead
8
SG (signal ground
SO WHICH ONE IS RIGHT:
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:15 GMT-3