From: Li Chaoyong (hughcyli@xxxxxxxxxxxxxxxxx)
Date: Thu Apr 20 2000 - 23:32:34 GMT-3
----- Original Message -----
From: "Scott F. Robohn" <sfr@ccci.com>
To: "Kenneth Kriel" <kkriel@netscape.net>; "ccielab groupstudy"
<ccielab@groupstudy.com>
Sent: Saturday, April 22, 2000 12:36 AM
Subject: Re: ATM CLIP ->LS1010 -> LANE
> Kenneth,
>
> Answers below...
>
> Kenneth Kriel wrote:
> >
> > Ladies and Gentleman,
> >
> > My mind tells me that question (1) is impossible, but experience
has taught
> > me not to be so cynical, I hope that someone could answer the
following two
> > questions :
> >
> > 1. CLIP on 3600 --> LS1010 --> C5K LANE
> > Is it possible to test my CLIP config by doing a ping to the C5K
int sc0
> > with a PVC (aal5snap) config on the LANE module ? Is there another
way ?
>
> The LANE module does not support CLIP. It's a _LANE_
> module.
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
You can bind a PVC encapsulated with aal5snap to a VLAN.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_5_3/atm
_cfg/pvcsatm.htm
>
> > 2. CLIP on 3600 --> LS1010
> > Is there a way to configure CLIP on the LS1010 ? If so how ? any
suggestions
> > ?
>
> You can create a subinterface on the LS1010 that can serve
> as a CLIP client and/or server:
>
> int a2/0/0.10 multipoint
> ip addr 192.168.1.1 255.255.255.0
> atm arpserver nsap <arpserver-nsap> (or 'atm arpserver
> self' if you want this to be the ATMARP server)
> atm esi-addr 1010.1010.1010.0a
>
> Assuming the CLIP config on the 3600 is compatible, this
> should work. No IRB or BVI's necessary :)
>
> You could then route from your CLIP network to the ELAN that
> has a LEC on the LANE module.
>
> HTH,
> Scott
>
> >
> > I am trying to test and verify my CLIP config on the 3600 but have
nothing
> > to ping.
> >
> > Ken
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:15 GMT-3