From: Li Chaoyong (hughcyli@xxxxxxxxxxxxxxxxx)
Date: Tue Apr 18 2000 - 03:27:16 GMT-3
Why use mask 0x0001? It seems that the SSAP of NetBIOS can be 0xF0 or 0xF1.
----- Original Message -----
From: Ryan B <rbenigno@home.com>
To: Jay Chandradas <jay@mtieast.com>; 'Li Chaoyong ' <hughcyli@holybridge.com.c
n>; <ccielab@groupstudy.com>
Sent: Sunday, April 16, 2000 6:26 AM
Subject: Re: How to filter NETBIOS in DLSW PEER
> Looks like the original question was asking how to allow only NetBIOS and
> not other traffic... In this case, a NetBIOS access list doesn't help him
> at all and he does indeed need an lsap access list... On our trusty
> documentation CD, under "Configuring Source-Route Bridging" we find an
> example of filtering SNA & NetBIOS...
> (http://www.cisco.com/univercd/cc/td/doc/product/software/ios113ed/113ed_cr/
> ibm_c/bcprt1/bcsrb.htm).
>
> ! Access list 201 passes NetBIOS frames (command or response)
> access-list 201 permit 0xF0F0 0x0001
>
> -Ryan (10 more days til San Jose...)
>
> int Brain0
> stress-level 255
> panic-mode level 128
>
> ----- Original Message -----
> From: "Jay Chandradas" <jay@mtieast.com>
> To: "'Li Chaoyong '" <hughcyli@holybridge.com.cn>; <ccielab@groupstudy.com>
> Sent: Saturday, April 15, 2000 12:51 PM
> Subject: RE: How to filter NETBIOS in DLSW PEER
>
>
> > Netbios traffic can be filtered by NETBIOS name and Byte-count. These
> > access list does not have an access list numbers. You will define,
> >
> > config)# netbios access-list host XYZ deny/permit < netbios name >
> >
> > These access-list are applied at the dlsw remote-peer statement. You may
> > have , dlsw remote-peer 0 tcp <ip address > host-netbios-out XYZ
> >
> > lasp-output-list are used for filtering by logical-link control layer
> > addresses.
> >
> > Thanks
> > regards
> > Jay.
> >
> > -----Original Message-----
> > From: Li Chaoyong
> > To: ccielab@groupstudy.com
> > Sent: 4/15/00 4:15 AM
> > Subject: How to filter NETBIOS in DLSW PEER
> >
> > I want to know how to configure DLSW peers to allow NETBIOS only.
> >
> > Use lsap-output-list ?
> >
> > Please help me.
> >
> > -----------------------
> >
> > Another Question
> >
> > In this condition
> >
> > R1----------R2
> >
> > R1 and R2 is runing APPLETALK EIGRP. How to filter EIGRP APPLETALK
> > ROUTE?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:14 GMT-3