Re: ATM

From: Scott F. Robohn (sfr@xxxxxxxx)
Date: Wed Apr 05 2000 - 22:39:50 GMT-3

• Next message: Kevin Baumgartner: "RE: OSPF into IGRP"
• Previous message: peter brown: "ATM"
• Maybe in reply to: peter brown: "ATM"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
You do need the signaling (0 5 qsaal) and the ilmi (0 16
ilmi) PVCs for CLIP and LANE.

You can omit the ilmi PVC if you define the full
nsap-address (versus esi-address) on the CLIP
(sub-)interfaces, but this requires you to put those NSAP
addresses in the ATM switch routing table. It's much easier
to use the ilmi PVC.

Scott

peter brown wrote:
>
> To configure ATM classical ip, is this command the only one you need?"ATM
> ARP-SERVER SELF" for the arp server and "ATM ARP-SERVER NSAP XXXXXXXXX" for
> the arp client. Do you need the pvc qsaal and ilmi
> statement on the atm0 interface

• Next message: Kevin Baumgartner: "RE: OSPF into IGRP"
• Previous message: peter brown: "ATM"
• Maybe in reply to: peter brown: "ATM"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:13 GMT-3