Re: Figuring Out IPX Frame Type from Debugs ?

From: Joel W. Ekis (jekis@xxxxxxxxx)
Date: Tue Apr 04 2000 - 09:12:18 GMT-3

• Next message: Hedlund, Brad: "RE: rj48 question?"
• Previous message: zheng jiang gu: "rj48 question?"
• Maybe in reply to: Kevin Gannon: "Figuring Out IPX Frame Type from Debugs ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
If you do not have the correct encapsulation type set, the router will not show
 any output in the debug ipx messages. You must choose the proper encapsulatio
n type first.

Joel

At 12:38 PM 4/3/2000 -0800, Kevin Baumgartner wrote:
>I believe in the debug message that comes back it will tell the encapsulation
type.
>What I would do to test this is setup two routers with different IPX network n
umbers
>and encapsulations. And have "debug ipx packet" on one.
>
> Kevin
>
>At 07:39 PM 4/3/00 +0100, you wrote:
>>I know it is possible to turn on "debug ipx packet" to figure out the
>>network
>>address. However how can I figure out the encap type using the debug
>>commands ?
>>
>>Regards,
>>Kevin
>>

• Next message: Hedlund, Brad: "RE: rj48 question?"
• Previous message: zheng jiang gu: "rj48 question?"
• Maybe in reply to: Kevin Gannon: "Figuring Out IPX Frame Type from Debugs ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:12 GMT-3