Appletalk AURP tunnels

From: Rob Barton (rob.barton@xxxxxxxxx)
Date: Thu Mar 30 2000 - 17:57:53 GMT-3

• Next message: jbazar: "RE: Appletalk AURP tunnels"
• Previous message: David L Stewart: "UPL meeting, 03/29/2000"
• Next in thread: jbazar: "RE: Appletalk AURP tunnels"
• Maybe reply: jbazar: "RE: Appletalk AURP tunnels"
• Maybe reply: Joel W. Ekis: "RE: Appletalk AURP tunnels"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hi all. I have an AURP tunnel across two routers. Both of these
routers can see the routes from the other side of the tunnel and are
learning the routes via AURP, but they cannot ping the networks on the
other side of the tunnle. Any ideas why this would happen?

Here is the tunnel config:

!
interface Tunnel0
 no ip address
 appletalk protocol aurp
 tunnel source TokenRing0
 tunnel destination 137.20.103.1
 tunnel mode aurp
!

Here is the routing table:

eu#sh app ro

• Next message: jbazar: "RE: Appletalk AURP tunnels"
• Previous message: David L Stewart: "UPL meeting, 03/29/2000"
• Next in thread: jbazar: "RE: Appletalk AURP tunnels"
• Maybe reply: jbazar: "RE: Appletalk AURP tunnels"
• Maybe reply: Joel W. Ekis: "RE: Appletalk AURP tunnels"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:07 GMT-3