From: Lee, Phillip (CAP, ITS, CA) (Phillip.Lee@xxxxxxxxxxxx)
Date: Thu Mar 23 2000 - 19:27:29 GMT-3
I have been told you can configure the two B-channels separately if you use
legacy DDR and specify the channel number in your isdn interface command ie
interface bri0:1 and bri0:2 instead of just interface bri0. Let us know if
this works.
-----Original Message-----
From: Aaron DuShey [mailto:adushey@yahoo.com]
Sent: 23-Mar-00 4:54 PM
To: ccielab@groupstudy.com
Subject: ISDN B-channel splitting
Can you assign the 2 B channels on a BRI to 2 separate dialer interfaces,
connect to 2 separate remote sites, and route between them? If so, how? So
far as I can tell, you cannot access these interfaces (I have a Cisco 804)
separately to assign them elsewhere-
thanks
Aaron DuShey
Consulting Systems Engineer
CCNP - CNX - MCSE - CNE - Citrix Specialist - ASE- HP Star
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:06 GMT-3