From: Aaron DuShey (adushey@xxxxxxxxx)
Date: Tue Mar 21 2000 - 20:48:06 GMT-3
set the CIR to a ridiculously low rate
map-class frame-relay first
frame-relay cir 1100
then run a few pings and check using the command show frame-relay pvc PVC#,
and it should show up-
Aaron DuShey-GE Capital IT Solutions
Consulting Systems Engineer
(858) 678-1524-Office
(619) 988-5170-Pager
CCNP - CNX - MCSE - CNE - Citrix Specialist - ASE- HP Star
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Simon Hopkins
Sent: Tuesday, March 21, 2000 2:33 PM
To: ccielab@groupstudy.com
Subject: FECN/BECN
I have configured a router for Frame Relay switching and can quite
happily get host routers to set the DE bit through the use of de-lists.
Traffic shaping is working fine too. What is baffling me is how to get
the Frame switch to set FECN & BECN for the host routers to be able to
act on it.
Any ideas?
Simon Hopkins
Muddypaws.net
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:06 GMT-3