From: Joel W. Ekis (jekis@xxxxxxxxx)
Date: Mon Mar 06 2000 - 17:05:13 GMT-3
You also missed the 2600, 3600, & 4500 routers. Both the 3600 and 4500 can sup
port ATM as well. The 1010 is not on the equipment list.
Joel
At 05:31 PM 3/6/2000 +0000, ejobson wrote:
>In the lab cisco seem to indicate that 2500, 4000 and cat 5000/5500 are the
>standard pieces of kit used. Are the ATM lab questions only related to these
>bits of kit or is it necessary to get access to an ls1010 before attempting
>the lab.
>
>Eddie Jobson (UK)
>
>-----Original Message-----
>From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
>Rob Ehlers
>Sent: Friday, March 03, 2000 2:34 AM
>To: CCIELAB
>Subject: Re: LANE and ATM
>
>
>Well, you can issue the commands on the card, but there isn't much way to
>test it, unless you have some kind of ATM switch inbetween. An old
>lightstream 100 would do, if you can find out. You can put a loopback on
>the ATM interface to get it UP,UP... I guess you could run some debug
>commands to see if it performing correctly after that.
>
>On Thu, 2 Mar 2000 josh@mstates.com wrote:
>
>> Is it possible to configure LANE without a LS1010 in the configuration or
>> must you have a LS1010 to complete?
>>
>> Josh
>>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:04 GMT-3