Re: Lat Service

From: Joel W. Ekis (jekis@xxxxxxxxx)
Date: Thu Mar 02 2000 - 10:58:16 GMT-3

• Next message: Charles Wolfe: "Re: loadbalancing in OSPF environment."
• Previous message: Dave Nadler: "Re: [sc] CCIE 5648"
• Maybe in reply to: Thomas Surber: "Lat Service"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
LAT with Autocommand

interface serial0
  lat enabled
lat service <NAME 1> autocommand show decnet route
lat service <NAME 1> password cisco
lat service <NAME 1> enabled

This is from Configuring DLSW and Desktop Protocols, a very good book. Pick
one up.

Joel, #5649

At 07:17 PM 3/1/2000 -0500, Thomas Surber wrote:
>
> If I want a lat service to run a command on a router how would I do that?
> Like say display the routing table or arp table on a router?
>
> Thomas

• Next message: Charles Wolfe: "Re: loadbalancing in OSPF environment."
• Previous message: Dave Nadler: "Re: [sc] CCIE 5648"
• Maybe in reply to: Thomas Surber: "Lat Service"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:03 GMT-3