From: John Garrett (John.Garrett.B@xxxxxxxxx)
Date: Thu Feb 17 2000 - 20:13:37 GMT-3
When multiple PVCs are defined on an ATM interface, I use a map-list to make
the remote address reachable. Why can't I ping my own interface address?
I even tried a map statement pointing to my address over the same vc, hoping to
go out an come pack for a ping, but that did not work either.
Here is some config:
R1:
interface ATM1/0
ip address 172.30.1.4 255.255.255.0
no ip directed-broadcast
map-group ATM
atm pvc 401 0 401 aal5snap inarp
atm pvc 403 0 403 aal5snap
atm pvc 418 0 418 aal5snap
atm pvc 424 0 424 aal5snap inarp
map-list ATM
ip 172.30.1.24 atm-vc 424 broadcast
R2:
interface ATM1/0.129 point-to-point
ip address 172.30.1.24 255.255.255.0
atm pvc 424 0 424 aal5snap inarp
map-list ATM
ip 172.30.1.4 atm-vc 424
In this configuration, R1 can ping 172.30.1.24, but not 172.30.1.4
just the same, R2 can pint 172.30.1.4, but not 172.30.1.24.
Any Ideas?
John Garrett
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:22:53 GMT-3