From: Brian Best (bbest@xxxxxxxxxxxxx)
Date: Tue Feb 01 2000 - 11:29:51 GMT-3
I merely wanted to point out that this comes from a configuration where the
peers are running over a FR network. I didn't mean to give the impression
that it was VoFR. Apologies for any confusion.
Brian
> -----Original Message-----
> From: Pylko, Eric [mailto:EPylko@bns.nec.com]
> Sent: Tuesday, February 01, 2000 6:14 AM
> To: ccielab@groupstudy.com
> Subject: RE: VoIP
>
>
> That is actually a voice over IP config, not a voice over frame. The
> dial-peer command would be a vofr instead of voip and would include a
> command in the form of: session target serial 0 <dlci> under
> the dial-peer
> statement.
>
> -Eric
>
> -----Original Message-----
> From: Brian Best [mailto:bbest@bestsolve.com]
> Sent: Monday, January 31, 2000 7:30 PM
> To: ccielab@groupstudy.com
> Cc: Ben Rife
> Subject: RE: VoIP
>
>
> Ben,
>
> I am right behind you...will be in RTP on 2/10-11.
>
> At the most basic level you would set up dial peers between
> two routers.
> For example:
>
> Router A
>
> dial-peer voice 100 pots
> destination-pattern 1212
> port 1/0/0 <------------------- FXS port that phone is
> plugged in to.
>
> !
>
> dial-peer voice 101 voip
> destination-pattern 1234
> dtmf-relay cisco-rtp
> session target ip4:10.1.1.1
>
>
> Router B
>
> dial-peer voice 100 pots
> destination-pattern 1234
> port 1/0/0 <-------------------- FXS port that phone
> is plugged in
> to.
>
> dial-peer voice 101 voip
> destination-pattern 1212
> dtmf-relay cisco-rtp
> ip precedence 5
> session target ipv4:10.1.1.2
>
>
> This is pretty much it. Unfortunately I don't have the actual router
> config, but this comes from a tested and working configuration over
> frame-relay. The real detail comes in when you have a need
> to shape the
> traffic and create a map-class to set cir, mincir, rtp
> priority queueing,
> etc.
>
> Best of luck to you.
>
> Brian Best
>
> -----Original Message-----
> From: Ben Rife [mailto:brife@bignet.net]
> Sent: Monday, January 31, 2000 3:45 PM
> To: ccielab@groupstudy.com
> Subject: VoIP
>
>
> I'm going to RTP on Saturday. I've heard that the FX ports are already
> installed in the routers. Can someone please post a VoIP
> and/or Voice over
> Frame configs?
>
> Thanks,
> Ben
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:22:52 GMT-3