From: Muralidhar Devarasetty (dhar_murali@xxxxxxxxxxx)
Date: Thu Jan 27 2000 - 13:40:38 GMT-3
Hi all,
Any one tried to associate "sh run" command with priv..level?
It works with all sh commands when I give "sh" but if run "sh run" it just
diaplays couple of lines thats it.It never displays all the config.Is it
b'se only normal enable will have the full access?
Murali
----Original Message Follows----
From: Brad Hedlund <BHedlund@LifeTimeFitness.com>
Reply-To: Brad Hedlund <BHedlund@LifeTimeFitness.com>
To: "'Alex Yeung'" <alex.yeung@lmco.com>, CCIELAB <ccielab@groupstudy.com>
Subject: RE: Access Privilege Level
Date: Wed, 26 Jan 2000 19:09:49 -0600
The answer can always be found on the Documentation CD.
In fact, I was just reading about privilege levels from the CD last night.
The Doc CD will be your only friend in the lab exam. Get to know it.
-Brad
> -----Original Message-----
> From: Alex Yeung [mailto:alex.yeung@lmco.com]
> Sent: Wednesday, January 26, 2000 6:29 PM
> To: CCIELAB
> Subject: Access Privilege Level
>
>
> Anyone knows any URLs or documents related to setting
> privilege levels?
>
> Alex Yeung, CCNP, MCSE
> Network Engineer
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:22:46 GMT-3