From: Natarajan Chidambaram (nattu@xxxxxxxxxxxxxxxx)
Date: Sun Dec 12 1999 - 04:58:48 GMT-3
IP IRDP is used for discovery feature. This is an interface command. Assume
that you have two routers connected to the same subnet. If a client is
trying to reach the outside world the IRDP's auto discovery feature will be
used to forward the packet.
To enable the IRDP the following things are required.
1. Enable the IRDP in all routers (IP IRDP)
2. Set the IRDP preference. (IP IRPDP PREFERENCE XXXXX- where X is the
value, the higher preference value router will be used to forward the
packet.
IRDP needs to be enabled in all the routers connected to the same subnet.
My two cents.
-Nat
-----Original Message-----
From: Brian Van Benschoten
To: ccielab@groupstudy.com
Sent: 12/11/99 6:05 PM
Subject: IP IRDP commands
anyone know how or where the IP IRDP commands are used? can they be
used to
allow clients to get a default gateway/route or is it just for routers
to
get a default route ?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:59 GMT-3