From: brian.m.edwards@xxxxxxxxx
Date: Wed Dec 08 1999 - 21:48:12 GMT-3
> Watch out there is a mistake in the All-in-one book. In Lab #14, they lead yo
u down a path to self-destruction. They have you use IARP to resolve the IP add
ress of the hub and then configure a map statement for the other spoke. Voila,
you have full connectivity.
>
> The problem is that IARP is now disabled, so if you do a shut/no shut on the
serial interface of the spoke you will lose connectivity to the hub. You must c
onfigure a map statement for the hub.
>
> At the CCIE lab, save some time at the end of your lab to reload all your rou
ters and verify that everything still works.
>
> I think the Caslow and the All-in-one book work well together. Caslow has bet
ter explanations of the various gotchas and all-in-one has more example labs.
>
> All-in-one has a good description of Frame Relay QOS settings.
>
> > -----Original Message-----
> > From: Clifton L. Stewart [SMTP:cliftonlstewart@home.com]
> > Sent: Tuesday, December 07, 1999 1:39 PM
> > To: ccielab@groupstudy.com
> > Subject: Frame Relay
> >
> > The All-in-One CCIE Lab Study Guide, chapter 4 is dedicated to Frame
> > Relay labs. Remember you will always have one router as a switch(DTE).
> > The DCE side of the cables will attach to these, specify lmi-type
> > (default is cisco). Inverse arp will automatically map DLCI's, if you
> > turn off this feature you will need to map and ip address to the
> > destination.
> >
> >
> > Chapter 4 of "Bridges, Routers, and Switches" also handle Frame Relay
> > using three routers in a hub and spoke environment. Good luck with your
> > studies.
> >
> > Cliff Stewart-CCNA, CCIE Candidate
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:59 GMT-3