From: ymadon@xxxxxxxxxxxxxx
Date: Fri Dec 03 1999 - 03:48:10 GMT-3
Have you got routing set up to reach the Loopback interface, remember you're no
longer directly corrected.
"hon-siong chan" <honsiong@hotmail.com> on 03/12/99 02:28:02 PM
Please respond to "hon-siong chan" <honsiong@hotmail.com>
To: ccielab@groupstudy.com
cc:
Subject: BGP Update-source
I followed Sam Halabi book on configuring a simple BGP peering by pointing
to a loopback interface. Scenario is as simple as follows:
-----R1 --------R2
Where R1 has a loopback interface and both are in same AS. In R1, command
as:
neighbor <R2> remote-as 100
neighbor <R2> update-source loopback 0
The peering can never be established since then. A "Sh ip bgp neigh" showed
"Active" status only?!
What's wrong?
Thanks in advance....
HonSiong
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:58 GMT-3