From: Ben Rife (brife@xxxxxxxxxx)
Date: Wed Dec 01 1999 - 13:30:53 GMT-3
Guys, I have a problem...
I have the following config on my router:
R1#
ip nat inside source list 1 interface Loopback0 overload
!
interface Loopback0
ip address 140.100.8.1 255.255.255.0
ip nat inside
!
interface Ethernet0
backup delay 1 1
backup interface Serial0
ip address 140.100.2.1 255.255.255.0
ip nat outside
!
interface Serial0
ip address 140.100.1.1 255.255.255.0
encapsulation frame-relay
frame-relay map ip 140.100.1.3 200 broadcast
frame-relay map ip 140.100.1.9 100 broadcast
frame-relay interface-dlci 100
frame-relay interface-dlci 200
ip nat outside
!
router eigrp 100
redistribute ospf 100 metric 1500 1 255 1 1500
network 140.100.0.0
!
router ospf 100
redistribute eigrp 100 metric 64 subnets
network 140.100.2.0 0.0.0.255 area 0
network 140.100.8.0 0.0.0.255 area 0
!
access-list 1 permit any
As you can see, I have NAT, OSPF, EIGRP, Redistribution, Dial Backup,
configured.
The problem is when I disconnect my ethernet int, my serial comes up
as expected and when I plug it back in, the serial goes down as
expected. That works, however, with the "ip nat out" statements in
place, I never get any routes in my table. I have to remove the "ip
nat out" and put it back in order to get routes in my table. NAT is
causing me problems. Can someone help me? I am stumped!!! If you need
some "sho ip ospf int" or "sho ip int e0" , etc, let me know.
4 days to go...
Ben
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:57 GMT-3